General Information
Introduction
Specifications
How to Order
During Your Order
At Delivery Time

Maintenance
Oil Change
Automatic Transmission
Coolant System
Rear Differential
Fuel System
Transfer Case/4x4 System
Part Numbers

Trouble Spots
TSB's
Recalls
Unsolved Mysteries

Tips and Tricks
Trailer Tow Mirror Lights
New FoMoCo Cupholders
Torque Converter Diagrams
Turbo Bolt Wiring

Frequently Asked Questions
Where should I get Fuel?
How long does it take to break in?
Why should I get a diesel?
How much can I legally haul?
What is a good price?

Manual Torque Converter Locking Diagrams

xpracr has sent in a few diagrams for those of you wanting to add a manual override to your torque converter. These diagrams are to help you out and for use at your own risk. TheDieselStop.com, myself, or xpracr is not responsible if you screw something up. Other than that, here ya go!

From xpracr:

Here is the diagram.  C1048 is the connector on the RH side of the
trans.  It is a 12 pin, oval shaped connector.  You're looking for the
purple/yellow wire for the TCC and the brown/orange wire for the coast
clutch.  Don't know how the coast clutch works.  Someone's
experimentation will need to be tried.

The second diagram is a view of the EEC (or PCM) module connector on the
firewall.  The pin number for the TCC is 54 and the Coast Clutch is 20.
This is an alternative place to tap into each wire.

NOTE: If you are going for a manual override, the pin needs to be GROUNDED and not connected to a positive electrical source.