|
|
Printable View (211 KB) |
Article No.
97-22-10 |
-
STALL - DURING TIP-IN AFTER A SHORT IDLE PERIOD - 7.3L DIT
ENGINE
|
| Publication Date: OCTOBER 27, 1997 |
|
LIGHT TRUCK: |
1997 ECONOLINE, F SUPER DUTY, F-250, F-350 |
CALIBRATION:
7-90C-R10, 7-90D-R10, 7-90K-R10, 7-90N-R10, 7-90P-R10, 7-90Q-R10
 |
WARNING: |
THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED
ENGINE. PERFORMING THIS MODIFICATION ON OTHER ENGINE
CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER
APPLICABLE FEDERAL OR LOCAL LAWS. |
ISSUE:
A stall during tip-in after a short idle period may occur on some
vehicles with 7.3L DIT engine. This may be caused by the
Powertrain Control Module (PCM) calibration.
ACTION:
Reprogram the PCM. Refer to the following Service Procedure
for details.
SERVICE PROCEDURE
- Perform normal diagnostics found in the
1997 Powertrain Control/Emissions Diagnosis (PC/ED) On-Board
Diagnostics II (OBD-II) Service Manual and service as required.
- If the concern still exists, reprogram
the PCM using the Service Bay Diagnostic System (SBDS) or New
Generation Star (NGS) Tester. Refer to the following PCM
Application Chart for correct calibration upgrade.
| PCM APPLICATION |
| Old Calibration |
Old Part Number
(-12A650-) |
New Calibration |
New Part Number
(-12A650-) |
| 7-90P-R10 |
F7TZ-RD |
7-90P-R11 |
F7TZ-RE |
| 7-90K-R10 |
F7UF-AGC |
7-90K-R10 |
F7UF-ANA |
| 7-90Q-R10 |
F7UF-ANC |
7-90Q-R10 |
F8UF-AKA |
| 7-90N-R10 |
F7UF-AHD |
7-90N-R10 |
F8UF-AJA |
| 7-90C-R10 |
F7UF-AFC |
7-90C-R10 |
F8UF-ALA |
| 7-90D-R10 |
F7UF-APC |
7-90D-R10 |
F8UF-AMA |
Obtain an Authorized Modifications Decal (FPS 8262 - orderable
through DOES II, 25/pkg) and list the date, dealer number, and
summary of alterations performed. Select a prominent place
adjacent to the Vehicle Emission Control Information Decal suitable
for installing the Authorized Modifications Decal. Clean the
area, install the decal, and cover it with a clear plastic decal
shield.
OTHER APPLICABLE ARTICLES:
NONE
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
| OPERATION |
DESCRIPTION |
TIME |
| 972210A |
Reprogram Powertrain Control
Module (PCM) |
0.2 Hr. |
DEALER CODING
| BASIC PART NO. |
CONDITION CODE |
| RECAL |
42 |
OASIS CODES:
607400, 607500, 611500
|
|
