|
I have made up a centrifuge filter that takes the fluid down to 1 micron.Used the bowl advertised on this site.
I have put a water/diesel mix through it and complete seperation.
WVO results in a creamy sludge being seperated along with soot etc. Who would want to eat chips etc!
WMO results in a fine black sludge but the oil is still black. Microns below 1?
The advantage is no filter purchases or blocking.
So far the brews have been used in a small 4 cylinder work truck. Still not commited to the expensive 7.3 but it is not too far off.
__________________
2000 F350 king cab 4x4,No engine mods,Roo Bar,Headlight and bonnet stone protectors,Inlet snorkel,flares on front,Engine driven air compressor and receiver,Hot water tap,tyre temp and pressure monitor,95 ltr fuel tank under right hand side,aluninium side steps,flat trayback,50ltr water tank under left hand side,heavy wired front and back for 4500lb electric winch, Bilnstien shocks,converted to right hand drive,battery conditioner,electric trailer brakes,heavy duty tow bar,synthetic oil in tranny,extra tranny coolerand filter ,tranny temp & pyro,
Ride-Rite airbags all round.Full flow muffler outlet at rear of vehicle.Engine breather mod.HHO generator
|
