- chip on ebay
- Gauges
- DIY Injectors
- Turbo pedestal mod.
- will a 2001 hpop work????
- Polyurethane bushings?
- headers... how can they work?
- Please help with vibration after 4" superlift install
- Tranny shifting funny after down pipe install?
- marine turbo
- good starting mods for a stock motor ???
- Skyjacker add a leaf- stupid question
- Update on rebuild.
- e4od swap with an r4100
- Height Gain for a F250 w/ D60, RSK and Superduty Springs?
- 315/75/16 fitment
- Question about Check Engine Light and Stage 1's
- Which Group 31 truck battery to buy
- ULSD ??
- I need a new transmission
- 35/12.5/16.5 AT tires, BFG stopped making them, anyone else make them?
- Stacks or No Stacks
- Has anyone ruined their EO4D with bigger injectors?
- gauge for compressor
- Used U S Gear Underdrive?
- Must have gauge!!!!
- bigger injectors need bigger turbos
- D60...Mabye not???
- 10k Mod problem
- Suspension
- How big of tires can you go with a 4 inch lift?
- stage 2's and d66 ?'s
- 4 Wheel ABS in an OBS?
- need quick advice
- torque converters on ebay
- Well my turbo is HOSED, What is everyody upgading to.
- which tc to buy
- How to install tw chip?
- dyno test question
- Sonix valve shifts too hard.
- torque converter
- Billet grills: how to open hood latch?
- E4OD to ZF-5, need parts list?
- BOOST PRESSURES
- tymar is a great place to spend tax refund !!!
- Replacing Brakelines
- TC Lockup
- hypermax?
- What positions/burns for tw chip?
- Gen-3 big oil ?
- RSK with Airlift in back
- Need some help deciding on a bigger turbo
- Window motor repair.
- Turbo compressor wheel
- Luk or SouthBend?
- 1995 F250 rods???
- nos ..will it take it?
- LMC truck question
- IDM mod ?
- Hummer tires
- License Plate Lamps
- Pyro probe location
- PCM Learn Time
- Propane Injection?!?
- IC and egts, didnt notice much difference
- RSK Stock Springs add a leaf
- caranage/ is there an upgrade
- Nut Lugs
- aftermarket valve springs
- Rancho RS5000 ??????
- Where to get tw?
- Stage 1 questions?
- just to get an idea of the power 160cc injectors might give me
- Intercooler kits / parts ?
- 5" exhaust
- Adding a steering stabilizer?
- TS Performance
- What are the weak points in the ZF 5 speed.
- Con O of OFE?
- whats the trick to get the master cyl rod outta the clutch master?
- chrome cowl
- South Bend OFE clucth with LUK flywheel...questions.
- ValAir clutches.
- CCV MOD and CAC
- Turbo removal
- IDM Mod....
- Fender flares
- D66 Info please
- Herculiner
- fuel filter
- tranny saver injectors
- best chip for economy and slight power increases
- Tell me about the pros & cons of a 203 thermostat please.
- Auxiliary Fuel tank Gravity Feed system
- Met a Member-Went for a ride!
- Anyone have specs. for a down pipe?
- CrimeStopper alarm /keyless/starter ?
- Thank you BEAN
- Key pad entry
- What guages would best match the silver insert by Procarparts?
- which injectors
- DANA 60 from same year F350?
- 96 psd sputtering
- 200,000 Mile birthday.
- Hate to ask?
- Anyone found custom replacement wiper blade arms....................
- down pipe or full exhaust
- Injector o-rings
- Various bypass filtration systems....
- DIY 160cc's
- Anyone making LED cab lights for OBS
- fire ball
- Piston ring gap.
- Turbo Upgrade..need info
- Looking for an H2E compressor map.. anyone have one?
- Done under the hood for awhile...
- bad turbo/white smoke
- DT466 CPS
- AIC Brackets
- Removing stock exhaust question
- How long to run synthetic oil? How many are using it?
- gauge lighting help
- TS 6-pos doesn't work on Cold Start??
- Tranny Cooler
- aftermarket turbo
- New stereo and radio wiring harness install with premium sound writeup
- Custom Lift Questions
- Torque Converter
- Trans sender
- Anybody tried a Cummins heater grid on your PSD?
- fs2500 oil bypass
- boost at idle
- Gear Vendors OD?
- fan clutch wrench size????????
- Gear Calculator Question: E40 Ratio?
- Anybody use SD Fabtech rears
- ebay chip, thoughts/oppinions
- Performance brake upgrade question.
- Performance brake upgrade question?
- DIY Stage 1's are in......HOLY COW!!!
- Stock exhaust manifold question
- Here's a tip about injector external o-ring installation
- Workhorse Power Module
- pillar gauges
- Coolant filter mod
- RBP fuel treatment
- uppipes donuts and wraping???
- Anyone running a single battery?
- add a leaf install problems
- Source for interior plastic paint?