6.0L Power Stroke Engine and Drivetrain [Archive] - Diesel Forum - TheDieselStop.com

: 6.0L Power Stroke Engine and Drivetrain



  1. Coolant PRO, CON, questions, problems...COMMENTS PLEASE!!
  2. Defective reman Ford EGR valve?
  3. Sudden low voltage when driving
  4. Performance Mfg Coolant filter
  5. 6.0 HYDRO LOCKED?... MOTOR BLOWN
  6. New Turbo: Relearn Procedure Required?
  7. alternator question
  8. 6.0 Rebuild or Replace?
  9. Help me with my ICP issue, possible IPR valve problem???
  10. No EGR Duty Cycle reading with ScanGauge II
  11. #5 glow plug circuit fault
  12. '05 F250 6.0 w/ 66,000 miles bad oil cooler
  13. 2003 6.0 must dos?
  14. Misfire post coolant flush, egr and ebp sensor clean
  15. B1318 coming from multiple CAN modules
  16. CAC Clamp Springs?
  17. Can the injectors themselves (spool valves) leak air in a leak test? (not the top o- ring)
  18. My 6-Liter thinks it's a Hummer
  19. What do these repairs mean to you guys?
  20. Camshaft Sensor Test
  21. Battery light Flicker
  22. Injector questions
  23. Back Together but No Low End Power and Smoke
  24. Dead engine P2614 code
  25. FICM good voltage bad codes?
  26. Can I crank or run the engine with a valve cover off without a mess?
  27. transfer case not engageing. Help.....
  28. Engine Fan??
  29. Ohm testing injectors / harness? on 06 e350
  30. 6.0 rebuild vs new engine
  31. Need help with idea for higher PSI at air comp for HPOP leak test
  32. Oil Capacity for first time fill after new Oil Cooler, Turbo?
  33. testing the IRP
  34. please help 6.0 no start again
  35. 04 6.0 A/C clutch ??
  36. 2005 6.0 turbo probs
  37. Engine oil and Engine coolant
  38. Need some advice on a cooling issue before my next big trip in 3 weeks!!
  39. A/C Clutch Disk fell off, can it be replaced in place?
  40. Waterpump failure?
  41. Alternative coolant flush proceduer
  42. egr valve
  43. ICP code and replace, no help
  44. Tips for re-install of EGR Cooler, OC, Intake, Turbo...?
  45. 04 , 124K miles runs great , buy it?
  46. Trying to do the right thing, fluid questions
  47. Exhaust manifold bolts?
  48. Turbo failure
  49. pulled HPOP tonight. (hot start issue) Should I be able to blow 40psi air in discharge tube outlet &hear air@inlet?
  50. Head studs and EGR Delete
  51. 6.0 no start like no one has heard that before
  52. Fuel issue
  53. Gear change
  54. new injectior replaced
  55. New Ford T-Stat ECT still 184-186
  56. IPR KOEO voltage question
  57. Torque specs and manuals
  58. To VC-9 or not?
  59. 04 6.0 Rough idle/White smoke
  60. Shaved heads may need new pushrods
  61. New oil cooler, brand?
  62. Low power on hills, engine noise
  63. Died when running to no start
  64. Please help fill in the blanks: Picture Included
  65. 6.0 acting weird...
  66. Could it be the fuel pump or throttle position sensor?
  67. 6.0 Rebuilt from ground up - Program or leave stock??
  68. ICP jumps to 10,000 PSI
  69. B1352 and no start
  70. Oil Cooler Assembly: Need help identifying where small o-ring goes
  71. Truck will not run smooth until warmed up
  72. Surprised
  73. Girguling / bubbling sound & air from oil filter housing with or without IPR actuated, runs decent, no hot start
  74. Ficm Replaced and RPMS high no power
  75. Thoughts on ForScan
  76. How Much Oil?
  77. Bad fuel pump maybe
  78. Need Help Buying a 6.0. maybe
  79. Exhaust or turbo restriction.
  80. Up tube exhaust leak at turbo.
  81. 2005 limp mode light coming on
  82. No Starter Response and Tow/haul light flashing
  83. Fixing The Radiator Nipple Fix
  84. considering replacing my 7.3 with a 6.0
  85. Am I Driving on Borrowed Time?
  86. Standpipe Replacement Questions
  87. Coolant system Questions, & EGR delete/defeat/block etc....
  88. ScanGauge II in - EOT/ECT not looking good
  89. Dead and replaced battery, now only 3-4 psi in Turbo
  90. Bed Plate Leak?
  91. How tough is in-chassis Head Removal?
  92. studder shifts and high egts
  93. 6.0 Starts, dies, cranks, stutters, then starts.
  94. Dead as a door nail
  95. EGR delete and other upgrades
  96. 6.0l (2004 350) No start periodically..
  97. 07 F250 front hub help
  98. Coolant question
  99. Fuel Mileage Advice?
  100. Question for the techs about a reman 6.0
  101. gettin ready to burn the ford .need advice before the fire.
  102. Advice Needed
  103. Tow/Haul & Transmission Issues
  104. 6.0 runs smooth but Zero Power. IPR?
  105. New member! Tranny help!!!
  106. Visible pitting in Turbo: clean, rebuild or new?
  107. Oil and fuel additives needed
  108. Been awhile since I posted.
  109. Just replaced injectors now no start
  110. Altitude and 6.0
  111. fuel gauge wiring
  112. Blown white smoke...lots of it
  113. No cold start 6.0 possibly stuck at camp.
  114. Coolant leaking
  115. injectors bad, or not, or who cares?
  116. No Crank No Start Help
  117. Oil Flow while Cold in a Torqshift.
  118. Have daughter's truck for a week - what to check/fix sigh!
  119. why cat1 coolant anyway
  120. Help! No start
  121. Injector cause jerking at 60 -70 MPH ?
  122. Thank you
  123. Miss, No Power
  124. Injector Electrical Self Test only with hot engine?
  125. reinstall turbo drain tube
  126. Corelation between trans temp or level and cooling fan?
  127. 6.0 No Start
  128. New front brakes grinding
  129. Jerking in 2005 6.0
  130. Engine Oil pressure sensor stripped
  131. Starts and Runs, then dies
  132. More noticeable clatter when cold
  133. clutch fan, temp gauge, power loss
  134. ICP sensor Interchangeable?
  135. Truck won't start with AE plugged in
  136. 2007 F350 starting problems
  137. Major repair advice needed.
  138. 6L, over heating
  139. Manual Tranny - Clutch Pedal Return
  140. my appologies
  141. 2003 F250 6.0L ( No Start)
  142. Instrument cluster issue and Tow/Haul
  143. Overheating and AC issue...
  144. Ac not staying cold!
  145. Bad Head Gaskets?
  146. Bad Head Gaskets?
  147. What Now!!
  148. What to expect....
  149. New Head gaskets, oil and Re-install???
  150. 06 rear axle nut torque