- HELP..Fuel Milage Upgrade !!!
- I need dimensions of the DP Tuner F5 switch
- Up Pipes
- DP 3.5" or 4" ?
- Anybody running a ball buster turbo
- sct tunes for the 7.3
- DP-Turner on the Way!!! :-)
- ATS and factory waste gate question
- What it takes to get to 600 HP?
- Advice on mods for my new truck
- tranny ????
- DP Tuner and Gray CPS Mileage Issues
- Question about leaf springs
- what do u think
- Injector choices
- MBPR 5" exhaust on a 99 7.3
- Modifing Early 99 to Late. Downpipe Question.
- Exhaust and Fuel economy
- pcm calibration code?
- new injectors and idle knock?
- Anyone know about AutoEnginuity program
- Exhaust Brake Modules
- beans or swamps?
- installing gauges
- Got my eyes opened!!
- Engine Monitors - Help me review!
- Compressor wheel is chiped
- Reality
- LoJack Ignition Kill on The Diesel Engine
- Afe....s&b...best Choice???
- air dog
- Wada ya think of this?
- Gotta bad turbo from someone on here, how long do you think it has?
- not a question, an apoligy
- Dipricol wiring harness question
- Question about A Pillar gauge mounts
- Dieselsite crossover installation
- Boost Psi?
- Quadzilla Commander Causes Surge
- Fuel Bowl Delete
- Have ? about Turbomaster Wastegate controller
- Is hpx oil crossover line worth it?
- DIY tymar??
- Boost pressure
- DIY D66 Dominator turbo for early 99 7.3?
- plug in tunner
- Quadzilla Monitor Boost Accurate?
- In-Line Pre-Pump Filter Help
- y2k 7.3 upgrades.
- Injector change and stuff
- If your removing stacks...
- If I get a little knock after REG RETURN, do I need to replace the LL8, damage?
- Turbo surge / stall ???
- Replacement Shock Preferences
- Pretty major install in my near future!!
- Need some bolt torque specs please, Diesel Techs...?
- a few questions
- How high of egts are you guys seeing?
- F250 transmission trouble
- Engine Parts?
- Reg. Return In Tank Mod.
- Pillar or Cubby Gauges
- Edge evolution?
- Injector education
- glacier diesel fuel filter
- ATS Compressor Housing
- Nos
- installing a racor R60T fuel filter
- adding low perssure fuel pump
- best chip
- ATS Turbo
- Fuel Pressure ?
- cold air intake
- Engine won't start after regulated return, need ideas
- I need help installing gauges
- Installing trans cooler on 99' PSD any images anyone?
- Easy muffler change
- installing diy tymar need help
- Question for those who've done the early 99-99.5 conversion and removed their intakes
- hpop questions
- Turbomaster and ATS housing- will they work togther, who is running them together?
- What should I expect from BTS tranny?
- Walker and Zoodad Mileage? See It Here!
- Thinking of putting a chip on my truck need a little help
- Ats Housing & WVO ?'s
- New Gear Ratio's?
- Soot on up pipe
- dually question
- turbo timer?
- What's the most efficent & cost effective way to build HorsePower???
- Dieselsite coolant filter kit question
- Header wrap or not on aftermarket down pipe
- Bellowed Up-Pipes: Ceramic vs Std?
- Bigger trans cooler
- Turbo Master Wastegate Install
- Thinking about a few more upgrades and need you opinions please?
- What next? Help me spend just a little bit more $.
- Wastegates
- Upgrades
- Are these mods worth it?
- Leather Interior
- Opinions on Stacks
- Last up-pipe belt finally out - Thanks to a carbide bur on air grinder
- Ignorant about exhaust
- Fuel rail cross over kit
- flustered
- turbo waste gate tube
- factory tbc from 2005 into a 2000?
- State Vehicle Inspection with the straight pipe
- 2002+ Cruise Control Kits work on 2001 trucks!
- Water Injection
- k&n air filter oil
- change of plans
- Hypermax Maxchip
- ATS/Wicked Wheel Combo
- DP Tuner/SCT question?
- 6.0 Intercooler
- Fried PCM rebuild or not?????
- H2E and Aurora 2000
- chip problem
- Oil By-Pass Systems
- Intercooler/Nitrous questions
- Bigger cooler
- What do you see for boost W/ dp 80 econo
- what do you guys think about this setup???
- ATS Housing and factory exhaust
- DIY Tymar
- Ny & Pa
- Overboost Annihilator vs Boost Pressure Relief Valve
- injector recomendations..
- installed chip engine runs a little different in mid setting?
- PICS-Turbomaster binding, what am I doing wrong? Installed ats housing also.
- 4.10 Gears and 315s Is this what I need?
- pedistal that will not seal
- Going to look at a 01 F350 Crew Cab 7.3 4x4 Today, what should i look for?
- is Alternator Instalation a DIY?
- 7.3 down pipe help
- Looking for gauge recommendation
- DP Tuner - ???
- up-pipe problem- 2 of the 4 bolts stuck in the manifold
- ottomind manual and stacking ?
- Whats the simple biggest way you have seen to quiet 7.3 cackle?
- 95 IH up-pipes Part Number?
- TN HighFlow outlet doesn't fit Downpipe
- Transmission running hot
- Need help and opinions fast
- If you get new exhaust manifolds (Stock uses no gaskets) how do you prep the surfaces
- Made BTS appt.
- DIY ebpv exaust brake Schematic
- Early 99 F350 CAI