- coolant temp probe hook up
- Yoke torq spec?
- Fuel bowl drain leak
- Blinking OD light
- electric fuel pump guestion
- Glowplug broken off......................
- 97 Front Spring Conversion to SD???
- TEE-5 Programming, No High Cold Idle?
- Wix & NAPA Fuel Filters
- Help me find a certain truck
- ac question
- No start...AGAIN
- Got another F350
- Power Lumbar Support Air Bag
- Help! brake lites(i think) staying on at 1/2 or less power-cuasing TC lockup problems (UPDATE)
- New ICP and stock ICP look different
- cutting web on turbo pedestal
- Confused on Clutch Master Cylinder Replacment
- '95 Idle Issue
- Truck wont start
- Bouncing ideas for my Dad's truck....
- Injector orings
- E4OD 4x4 Trouble shifting into Drive
- Starter Strange behavoir
- No Start
- foul exhaust smell please help!
- removing turbo 1995 ca. model
- front tires all of a sudden hitting bumper when turning????
- 96 PSD dieing after warm up
- Right side oil leak
- 1995 7.3 L diesel
- drain oil from oil cooler???
- Poor acceleration-Help Alaska power strokers
- Help with F350 Springs??????????
- Stock Fuel Pump Performance?
- I know Rotella oil is good but how about this?
- Lucas Oil Treatment
- AC manifold hose leak
- hpop
- looking to buy a psd, have many questions
- What grade oil ZF
- rear dually fenders
- back pressure
- Shuld the under-VC plugs have rubber seals???
- Hard/No Start when cold
- engine swap
- 99 7.3 tranny
- AIC
- Tailgate ?
- Oil leak in oil cooler and rad leak on block heater
- Dont trust A/Z on a starter test
- What ype and size o-rings for the IPR?
- Running a little rough
- Size bolt for ZF5 access panel cover
- fuel regulator
- 1995 F250 how to best adjust door & problem with doorlocks
- Smoking & Hard Start
- Has anyone come up with a good fix for shorting VC connectors???
- where to hook up hipressure guage??
- Fuel pressure gauge
- Ran out of fuel
- in the market !!
- What is the factory rated MPG on the 97' powerstrokes stock?
- '96 starts great when cold, won't re-start once warmed up
- 13mpg... Why?
- Rabs Theory
- 94 ZF5 R & R
- fuel an tranny leak
- Going in reverse w/ TTB front end ??
- Truck smokes under load?
- Rookie Question
- 97 F-250 Extra Cab 8' Bed.......Weight of Truck??
- Rear Bumper Mounting Bolt Size?
- still surging and slightly bouncing speedo
- Buying parts from e-Bay question
- Steering Wheel Question?
- Two things
- Tire size
- New P/N from NAPA
- A/C compatibility
- Fuel Pump
- Could this be a baldwin in disguise???
- 1997 Ford No Start
- 3.55 swap with 4.10 from 1986 to 1997 F350
- 1997 F250 Powerstroke w/ engine miss. Please advise!
- very bad mpg
- What sensor is this?
- ebps sensor fooler?
- is a 7.3 a 7.3? also towing questions with these years
- clutch pedal help
- Water Pump
- oil pan
- Accel pedal help please!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
- E4od oil drain?
- Auxiliary Powertrain Control Module
- All engines the same in 1997?
- Keys locked in my 97.
- Help with Moog Ball Joints
- Headlight lense, replace/polish/or upgrade
- 2002 exaust in 1995
- Broke gear selector on column
- Vacuum pump has gone out was shearing the metal housing apart.
- Power Stroke Dimensions
- low sulfer fuel concerns
- Truck quit
- Still having HPOP problems
- Truck wont start. Was a progressive end
- Coolant Temperature Gauge Sending Unit
- Motor mounts
- Need help with Fuel Problem
- replacing rear main
- recycling engine oil in your diesel??
- injector pump
- Rebuilt filter housing. Think I missed an O-ring.
- No low beams
- Is there an overall "best" Dana 60 for OBS trucks?
- NEED HELP was running. shut down. no start !!!BURRRRR!!!
- Building a flatbed - easiest way to wire lights?
- Help? Nut on dipstick connection at oil pan
- Dana 60 problems - bearings? hub seal?
- 95 f350 ecm , idm
- Eelectrical trouble: engine quit
- How do you check for the bad poppet seats ?
- worn clutch pushrod/bushing
- wiring harness source?
- ZF5 Q?
- My experience removing and istalling the vacuum pump pully
- Sensor PSI for change fuel filter light to come on
- blueish-gray smoke and strong diesel smell on startup
- bad skip when engine is cold
- Missing part on hub- cap?
- Two part question, wait to start and power steering line....
- Transmission Help (E40D)
- april of 94
- can converter cause vibration?
- dipstick tube upper seal/grommet P/N?
- Changing orings, should i rebuild ipr?
- Steering grear box input shaft; is it splined or squared
- 200,000 miles!
- E4OD fluid
- DTC # 0P0603
- chasis lubrication points???
- Rear Brake Size?
- Artic F350 - How to resurrect it?
- Torque specs.
- how do I test the MAP sensor?...
- Lower radiator hose spring question
- Turbo impeller torque?
- I'm guessing DMF going out?
- What an idiot! I put TOO MUCH OIL in the truck.