- DIY Intake?
- crazy question
- How much for dyno?
- WHICH CARR Superhoop steps for my crewcab?
- front axle
- Give Me Your Monster Box Testimonials
- Post deleted by JLester
- tymar questions
- Anyone try one of these?
- is this turbo any good for a 95 stroker
- 40/20/40 seats
- exhaust brake
- CB mounting
- EBPV
- Muffler direction
- k&n air filter
- Tire??
- What type shocks?
- 4 wheel drive wont work
- diff. between 96 and 97
- Ac Mod
- Factory cupholders
- Chains from axle area??
- Fender Flairs
- Stock Injectors and 1.0 Exhaust Housing
- Down Pipe Results???
- Post deleted by JLester
- Dual Mass Flywheel
- How many going to the National Rally next week?
- 94-97 Ford AIC Bracket
- Post deleted by JLester
- Exhaust size with 3" downpipe?
- Downpipe
- turbo mod: back presure control
- KC Driving/Fog Lights
- Ford AIC install
- Two Hot Days at the Track
- Add-a-leaf?
- intake ?
- Another Exhaust ?
- level truck
- Engine Stalling
- map mod ?
- what other gauges should i run
- Dead end fuel system for 7,3?
- custom intake for sale from H2E install
- oil fill neck extention
- Pics are up - under the hood!
- Hot day at the track....updated with pic
- DIY Intake
- high hp '97 two tone red in Portland/Scappoose, OR area?
- Questions on EGTs with chip
- Super Duty up pipes
- tranny chip?
- Straight Pipe?
- 0-60 times?
- Boost & Oil Temp Install
- Exhaust Finished & +80 hp Installed
- Broke 97 for sale on eBay in Fort Smith, Arkansas
- Intake Mod
- 6 pos. chip and cel
- Remote mount coolers
- Coolant Eye???
- Flatbed
- where do i go to get a chip hmmmm choices?????
- BTS trans fluid????
- building an hx50
- Got the 1997 PSD home......
- High EGTs and Other Observations
- another annoying exhaust question
- X-Monitor? Anyone Use One??
- Just wrecked truck...time for a lift kit...
- injecters???
- Post deleted by JLester
- Banks & trany cooler question
- edge
- Shimmind fpr
- 1996 F350 CC Dually Upgrades
- Water injection?
- Chip -vs- tuner
- ZF5 to E4OD Swap
- TWildman chips
- got my 6 pos chip!
- TruSpeed
- Fuse
- 10 K Pedal Switch
- converting from a 5 speed to a 6 speed
- Fog Lights - '96 F250
- Very Tempting....
- Is 42 PSI enough at WOT?
- XL to XLT
- OMG I Think I love Bean!
- Moab Return
- Tranny acting goofy...
- Faze Gauges
- 94-97 Stock Muffler
- Looking for more lift...
- speedometer correction
- Honestly it just.......
- turbo timers again
- Hood Scoops for Turbo and Intake??
- video of 1200 + dyno run
- lockers
- Boost memory
- Burnout contest.....
- compressor wheel is black!?
- Can these work?
- There's a french horn in my turbo...
- So, what else to do?
- AFE stage II
- clutch up grade.
- what gears
- Gauge Wire
- 10K mod...seems to run out of power over 2500 rpm...
- PROBLEMS STARTING
- Will not start
- ISO 5011 Air filter test
- Are stacks worth it?
- lowering the psd
- on board air york ac compressor
- just got back from the pulls
- Bilstein Shock Question!!!
- FPR measure, clean, measure, shim, measure.
- 1997 e40d with edge evo driving temps
- H2e SD 3.5" dn pipe??
- BIO diesel and Performance mods
- Which Electric Fans Worked..???
- This thing is AWESOME!!!!
- H2E Drivability Questions ???
- Turning valve cover breather around?
- does it even exist?
- Why is my Torque Converter Unlocking???
- 4r100
- 10k mod
- Question for those with stage 1 jectors..........
- h2e on ebay
- Am I the Only one? Hypermax H2E
- Remote Start.....
- Clutch question
- Dyno results!
- Post deleted by JLester
- more boost questions
- Down Pipe Question
- getting ready for first pull and looking for tips
- 1996 F250 7.3
- 2wd lift kit?
- cowl hoods
- Rim size?
- Made the call
- Does this look good for stock Injectors?