- new batteries, still having start problems
- Front wheel bearing grease
- Intake "huff" when engine is warm
- What is the difference between 1805855C2 and 1805855C1 heads?
- What is the difference between 1805855C2 and 1805855C1 heads?
- Cracked heads, replace?
- Need a head.
- started on g/p alone @ -12!
- Injector pump isn't working
- Will a 1986 6.9 swap to 1996 F350 460 gasser vehicle?
- Fuel water seperator hose?
- newbie here fuel pickup hose question
- Heat Question
- 83 6.9 2wd front suspension question
- do you have a C6 trans AND a Gear vendor??
- alternator spade connector. number 1 spade connector
- New GP old Problem
- Turbo help
- Stumbled Upon This
- Where to get Oil Cooler and Oring set?
- mileage vs. cold
- 6.9L lift pump leak
- Front Suspension - Radius Arm/I Beam
- Oil leaking....pretty bad!
- truck not starting after new fuel pump
- Crank seal leak?????
- Injector pop testing
- wont start; solenoid, gp's or battery?
- transfer case yokes
- C6 issues :(
- Replacement battery cables
- Bell housing and tank selector broke on the same day!
- Water pump replacement
- 1986 f250 6.9 belt question
- Stiff Ignition
- Odd sound.
- Heater core?
- clutch line
- front windshield
- will not start without help 6.9
- injector pump buildup
- Im gunna blow it up!
- Which injector kit?
- power steering pump
- Door latches on my '84... adjustment?
- 1987 F-350 Won't Start
- retrofit
- Is this Typical?
- Need a good oil cooler in Sacramento area
- voltage question
- A few problems
- Good Vendors
- can i do this?
- turbo removal
- GVWR, GCVWR for '85 F-350 dually flatbed?
- air in the filter
- HELP
- smokes like a freight train
- i got the good stuff
- Stuck hood
- White diesel smelling smoke!!
- Coffee canister?????
- Crack near block heater question
- 7.3 idi block vs 7.3 powerstroke block
- Good by 6.9 forum
- Anybody here on Oahu, Hi
- oil cooler rebuild?
- Another Dana 60 question
- what is this?
- junk yard ats turbo.
- kick down rod
- 6.9 motor
- Smoke Stacks
- truck stalls out 1987 6.9L
- Post Injection Pump Installation.
- 86 tach wiring
- Fuel Selector Valve problem
- Porsche idea for a Banks turbo truck
- will this be ok?
- 1987 F250 6.9 sending unit
- Ignition please help
- 6.9 drop into 88
- Headlight mod.
- Can't get clutch to bleed
- 2WD Radius Rod Bushing
- Proper steps for testing cold advance
- 4x4 not working correctly
- '86 6.9+Hypermax Spotted on CA Craigslist $750
- vaccum modulator valve
- Idea for clutch slave tool
- Free to me Coolant.
- Tranny issues
- Leaking Driver's Side Valve Cover Gasket
- 1984 f250 6.9l
- Swapped in a 7.3, can I still hang out here LOL?
- stacks on a dually
- 1987 F-250 p/u Diesel fuel leak
- Source for parts?
- fuel tanks drain into e/o?
- What kind of fuel mileage does a 83 6.9 turbo get?
- picked up a used 6.9, what should i do before install?
- Turbo
- broke my cold start advance
- Im new and would like some information.
- Valley cover
- almost new member
- higher rpm engine vibration
- Water pump replacement? I think
- injector o-rings
- Not sure where to look?
- is oil pressure sending wire in glowwplug harness?
- what size is my front fuel tank?
- New Diesel Owner and First Time Poster
- Poor Heat please help
- 85 Ford 6.9
- heater door
- Feels like somethings holding me back.
- safe crusing rpms
- a couple questions froma novie mechanic on a 1985 6.9
- What trany should I use or can I use
- Retorquing heads.
- Winterizing the truck and me
- More problems
- Using a flairing tool
- My before and after on 85 f-250
- FUEL PUMP QUESTIONS
- Preparing for turbo install
- 6.9 headers
- heater problems and it's -27F
- What's this fuel line gizmo?
- 86 6.9 wont start w/o starting fluid
- E 150 seats
- need help with my cab
- powerstroke into a 86 idi
- 4R100
- Kansas City
- Wellmans Rock!
- 6.9 four speed making noise
- hard steering saginaw 143 pump
- Fuel Pump replacement
- now or later
- Ranger Overdrive
- Horn broken, watch for finger.
- Light load timing advance...
- need hydroboost motor!!!
- 1984 axle ratio
- direct wiring tail/running lights
- Turbo 6.9 guage readings
- control arm bushings
- alternator or batterys