|
Fit and Finish
Great Website!! 'Been reading for a while, but just registered today. I ordered a 2001 CC, PSD, 4X4, Shortbed, Lariat, and it arrived at the dealer a couple of days ago. It's a courtesy delivery and the paperwork is not ready yet, so I can't pick it up. I sneaked onto the back lot yesterday to check it out (VIN # in hand). Looks great but, the left rear door, bottom aft corner is not flush with the surrounding body panels. It is pressed in about 1/8 to 1/4". I started to think it had been wrecked then repaired before it got to the dealer, but I found another 2001 CC on the lot and it had the exact same thing. I looked at several 2000's and they did not have the problem. Also, the front bumper is offset slightly to the right. Are these acceptable factory imperfections, or should I demand they be corrected prior to accepting delivery? Any comments would be greatly appreciated. Thanks.
P.S. It was built in Kentucky.
[This message has been edited by XC5Guy (edited 10-27-2000).]
|
Linear Mode
