|
new clutch
i already have the luk replacement clutch and i lost my throw out bearing at the drags...i was wondering what parts i should replace it with....while i have the whole tranny out i was going to just put a new clutch in it while i was at it something heavy dutier....i have the single mass flywheel .....what could i get to help me from losing my throwout bearing again....
i think it wa sthe throw out bearing...the clutch still engages and disengages...but a plastic retainer with groves for ball bearings came out onto the ground along with ball bearings....and if i ever put the clutch in it makes a grindign noise and it still makes the noise at idle jsut not as bad....
__________________
05 F 250 XLT extented cab PSD, guages, exterior stuff, recon stuff, SCT Xcal 3 innovative X street tune, silver line cool duals, mtx thunderform encolsure with two 10's, alpine deck.
96 F250XLT heavy duty, ext cab, PSD 5-speed, 4:10's/limited slip-so far homemade tymar intake with big filter ,diy stage 1's, ts 6 pos chip, 4 inch turbo back to 5 inch slash cut stacks, pyro and boost guage.reverse glow guages, replaced clutch with a LUK replacement,garmin street pilot, sirius sat radio, Alpine Cd player, Alpine Type R 12" sub, sony xplode amp in custom center console, diamond plate trim and side steps, Visor, bug sheild,
|
Linear Mode
