Diesel Forum - TheDieselStop.com - View Profile: RT

RT RT is offline

Lifetime Supporting Member

  Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. TooCoolTwo
    12-27-2018 05:36 PM - permalink
    TooCoolTwo
    RT:
    How are you doing? Hope you got around to rebuilding your turbo and that you are pleased with it.


    Thinking of having my calipers replaced with my next set of new rotors and pads. They are the 2002 factory originals with 238K on them. What has been your experience with new or rebuilt calipers in terms of good quality?



    Looking forward to hearing from you and hope you have a wonderful and Blessed 2019.


    Mike (TooCoolTwo)
  2. lmbbuilders
    03-14-2016 12:39 AM - permalink
    lmbbuilders
    Hi,a fellow member gave me your name. Hope you can help me. I have a 2005 lariat 6.0 with a/c issues. When I turn on my a/c the truck surges rough idle and wrench light comes on, I loose pedal response (codes p0108,0403,0405,2104,2123,2138,2139,2140)...I installed a new compressor, accumulator, low pressure switch, I reprogrammed PCM back to stock with newest version, I swapped the PCM, I swapped the a/c controls, I pulled off baro,icp,ebp sensors and it still does the same thing. The truck runs good except when I turn on my a/c. When I pull off the low pressure switch the a/c controls come on and air comes out of vents, I'm guessing my compressor is not kicking on though. Any suggestions would be appreciated. If texting or calling is easier, my number is 225-802-3992
  3. sailpadre
    10-26-2015 01:13 PM - permalink
    sailpadre
    RT, I thought you might have a thought. Last Tuesday I pulled a trailer about 45 miles and deadheaded the same in order to pick it up. Back to the same "O" after 400 miles of using no oil. Now it's a little hard on cold starts and rumbles until it warms up and blue smoke on start up. I drained the fuel filter and it had a darker tint to the diesel more than before. This time it showed #3 and #8 on the contribution study, it showed good when it was running good. I'm going to pull those and run them over to a diesel shop in Brownsville, TX for them to be bench tested. Right now I just want to be running in order to take care of my customers this winter and do whatever I have to when I get back to Colorado next spring. Any iders????

  About Me

  • About RT
    Location
    Texas
  • Signature
    2003 F-250 XLT Crew Cab 7.3L, Chrome BigTex Grille Guard, Quad pillar - 3 ISSPRO gauges (trans, pyro, boost) and DP-Tuner F6; Roush fuel pressure / temperature / oil pressure gauges, Ford Severe Duty AIS, 31 row 6.0 transmission cooler, ScanGauge II, Marinco mod, Walker BTM

    I wonder if clouds ever look down on us and say, "Hey, look - that one is shaped like an idiot!"

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Today 02:09 PM
  • Join Date: 12-24-2009
  • Referrals: 1

  Friends

Showing Friends 1 to 5 of 5

  Mentions

05-11-2017
12:18 PM - rustygold mentioned RT in post $2000 HPOP
...But I do agree with RT I would ask for the ...
11-27-2016
09:41 PM - Texas_proud77836 mentioned RT in post Cold start, a little advice please
...ps up to 14 when started. RPMs thump 100 wh...
12-06-2015
08:10 PM - thegreenmachine mentioned RT in post Changing coolant
...ld at 28 bucks a quart, then flushed a tota...
10-19-2015
01:50 PM - AG Jeff mentioned RT in post New site look and software upgrade Feedback Thread
...ity. Well done! RT - thanks and let us ...

  Quotes

02-09-2019
09:42 PM - RT quoted 8gitmusik1 in post Best FIRST START-COLD START advice
Are you a mechanic (your backgr...
08:57 PM - 8gitmusik1 quoted RT in post Best FIRST START-COLD START advice
... iPad using TapatalkRT, Thanks for the inpu...
08:09 PM - 8gitmusik1 quoted RT in post Best FIRST START-COLD START advice
... you jump on the starter, you have a chance...
07:53 PM - 8gitmusik1 quoted RT in post Best FIRST START-COLD START advice
... you jump on the starter, you have a chance...
07:10 PM - 8gitmusik1 quoted RT in post Best FIRST START-COLD START advice
...spin it with the starter until your oil pre...
01-25-2019
03:22 PM - RT quoted Calico5 in post 911 Assist fail
Gawd...how I love my "simple...
01-17-2019
09:11 PM - aklim quoted RT in post Gas in Diesel fixed. Now the fun begins. Help Needed
I would try and check f...
01-11-2019
10:12 AM - RT quoted Absolute in post
01-09-2019
01:22 PM - Absolute quoted RT in post Odd injector cup problem
There's a tool for anyt...
10:25 AM - RT quoted Absolute in post Odd injector cup problem
I have never seen an Injector...
01-06-2019
02:00 PM - Steve83 quoted RT in post Block Heater
That heater draws some ...
12:45 AM - txgp17 quoted RT in post Best programmer for a '2000 F250 7.3L
My experience as well. ...
01-04-2019
07:40 AM - ford_doctor quoted RT in post Metal shavings found in fuel system - Ford will not warranty
... EGR or exhaust aftertreatment concerns.
01-03-2019
10:44 PM - RT quoted HeavyAssault in post Metal shavings found in fuel system - Ford will not warranty
Less than 1% of 6.7L trucks have ...
02:47 PM - fedrlbiker quoted RT in post 1000 RPM Shake w/ White Smoke and 2700 RPM 'miss'
...e harness and pay particular attention to w...
10:08 AM - RT quoted blackout2 in post Best programmer for a '2000 F250 7.3L
I've had nothing but positive ...
12-30-2018
06:33 PM - RT quoted lj8215 in post 2002 7.3L Glow Plug Relay
Sorry.. Yes, it is grounded...
06:23 PM - RT quoted lj8215 in post 2002 7.3L Glow Plug Relay
The terminal you have circl...
12-29-2018
10:56 AM - RT quoted ArcticDriver in post Oil life indicator
What I have not seen is an explan...
12-18-2018
03:40 PM - RT quoted DonWarkentin in post Best Tool
Forget the wimpy 45,000 lumens. I...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome