Diesel Forum - TheDieselStop.com - View Profile: Gone Fishen

Gone Fishen Gone Fishen is offline

Senior Member

  Visitor Messages

Showing Visitor Messages 1 to 10 of 11
  1. corvettekp
    09-21-2016 07:57 PM - permalink
    corvettekp
    hello!

    From reading the different posts in the forum you appear to be the most knowledgeable concerning Detroit 90 engines and I would like to discuss the Detroit engine we have on our 85 Blue Bird if you have the time.

    Kelly Parker
  2. kennethbeeler@gmail.com
    06-25-2015 08:48 AM - permalink
    [email protected]
    Been a long time sense we last message . my 2001 fright liner fl60 with the Benz M906 eng . Yesterday it shut down and will not restart . i shot it with a bit of either and it fired up but shut down .so i now no it has to do with not getting fuel . can you help with where to start looking it has a little over 400.00 miles . thanks so much .
  3. tango97ch
    07-30-2014 12:21 PM - permalink
    tango97ch
    Gone Fishin,
    I'm new to this whole website thing, but I have a question for you since you seem very knowledgeable in Detroit's. I bought a 05 Coronado with the 14L Detroit. I bought it from an auction cause I'm a gambling man, but this Vegas trip isn't paying off. The truck has 685,000 on the clock and I seem to be getting some water/antifreeze in the oil. Not a lot but enough that when I open my drain plug a little it seems to drip about ohh maybe 6-8oz before the oil drains. I don't think that's normal. It appears to have a brand new head on her so I kinda eliminated that part. Do you have any suggestions on what my next move should be on locating the problem? any help is much appreciated.
  4. imcomininhot
    12-06-2013 07:45 AM - permalink
    imcomininhot
    Gone fishen
    Good to know you. Just moved from Vegas myself. I'm hoping you could gimme some input.
    60S 14L in a '06 Columbia, intermittent power loss. Sounds like boost is dumping on the R side in conjunction with the pulses of power loss, followed by an expectant soot out the exhaust. Obviously only happens during acceleration, loaded or not. I'm afraid of clogging up egr system with all that unspent fuel out the exhaust.
    I read your post about how it may be of 2 problems. I'll check the vpod and hope it's as easy as that.
    Thanks if u could kind Sir
  5. Algarb
    06-05-2013 07:55 PM - permalink
    Algarb
    Hi Gone Fishen,

    Thank you very much for your post on my forum. I had a quick question regarding your post about the even flow through the discharge outlets. Can you tell me where they would be located as I cannot seem to find any information on them in my detroit owners manual nor online. Thank you again so very much for your help.


    Allen
  6. detroitaust
    02-13-2013 01:56 AM - permalink
    detroitaust
    G'day. We have a 8v92 ddec3 to exactly the spec of the serial number.
    8VF179158.At this bulid spec we have liner kits.85. We also have cams j42 grind. All parts in this engine are genuine.Everything on the build spec has been checked over and over. This is exactly what came out of the factory. The engine makes peak HP at around 1650 to 1750 EVERY TIME.The best we have got out of the engine at 2100 is 390hp without code 42 in the injectors.430hp with it. We are looking for [email protected] 2100.The ECM is registering, 100% load, 22 degree pulse at 2100. It is reading 1300 odd ft lb on the computer, 900 at dyno. Mapping code 1056. All parts in this engine are genuine,cams, genuine cylinder kits etc. Boost at [email protected] is 21psi, a/box 22psi, ex temp 330degreesc fuel pressure 62. Dirty exhaust. Darkish grey only No white. Had injector change out etc with no change.1.520 heights. .1 pulse width difference on cyl.cut out between cylinders. Built lots of these things but not to this spec.
  7. cueball
    09-03-2012 07:35 PM - permalink
    cueball
    Hello, My name is Micheal, but I go by cueball on the forum. I Have a few questions about detroit diesel 2 strokes that I would like to get feedback from you on if you wouldnt mind ?! I know that there is alot of people on the forum that can help,.., but from my reading, from time to time I feel like your info would be the best for me and my situation... If at all possible ,,If you can find the time , Some kind of contact will and would be respected .. Thanks for your time ! (cueball)
  8. kerley
    07-10-2011 11:54 PM - permalink
    kerley
    6v continued.....I also seem to have more heat on the right side manifolds at start up versus the left side using an infrared temp gauge. So I am supplying more fuel to the right maybe? It is a non ddec silver 6v92 335 hp. 9f90 injectors. Thanks for your help and I hope all is well.
  9. kerley
    07-10-2011 11:51 PM - permalink
    kerley
    I exchanged some great tech information on this site a few years back. If you search 6v92 injector tube removal tube it will come up. Anyway I have a 6v in a Bluebird. I put heads on it and new injectors and all was well. I did have 1 injector tip blow off a couple years ago in Waco Tx. I got one from DD that was a little different number; they said it would be fine and it was. So getting to my problem. The way the fuel was plumbed to my pump through 2 primary filters. One is a raycor 1000 and then to a 30 micron spin on. There is a secondary after the pump. I never was able to keep the raycor and the 30 filled and when they would plug slightly I had fuel pressure troubles. SO....I eliminated the second spin on filter. The raycor is full and bus runs great.....BUT smokes like CRAZY at start up. It also seems to have a slight miss (half miss?) . As soon as I take off with it will clear up and not smoke again. Miss also goes away. cont'd
  10. loggingmechanic
    11-03-2010 06:57 PM - permalink
    loggingmechanic
    yeah i had 5 stuck injectors sorry it took so long getting back to you, too many doctor appts. broke my neck in a car wreck someone texting instead of driving ran over the top of my car.

  About Me

  • About Gone Fishen
    Location
    Lost Wages, Nevada
    Interests
    Fishing/camping/honey doo's
    Occupation
    Mechanic- Detroit Diesel Engines
  • Signature
    95 F250,XLT, 4WD, Auto Trans,bbshimmed,synthetic trans oil,4:10 gears ,Truck Trunk ,Nerf Bars ,crome Mud flaps, Aux. trans cooler, front diff. drain plug. External trans.filter, trimmed snorkel. American wheels water temp guage, front fuel tank mod,Warn Manual hubs,Putman class 4 hitch 212k mi.
    Currently also have 2012 Dodge 4X4 with a Cummins engine.

    It is said if you sit by the river and watch the water flow by long enough, your enemies will pass by. This I believe to be true. It is also possible to watch your loved ones pass by as well.
    Wife Candi 08/14/07 missing her always

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 06-21-2016 02:35 PM
  • Join Date: 04-28-1999
  • Referrals: 3

  Friends

Showing Friends 1 to 1 of 1

  Mentions

No results to display...

  Quotes

No results to display...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome