Diesel Forum - TheDieselStop.com - Reply to Topic
Power Strokes 1994-1997 General Technical discussion of topics related to vehicles powered by the Power Stroke engine in 1994 through 1997 models.

Thread: Bad starter? Batt Cables?? Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Diesel Forum - TheDieselStop.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
04-26-2008 08:58 AM
das5439 Make sure the connections are good from the batteries clear down and including the starter. These engines require massive amounts of amperage to roll good and it has to flow with very little restriction. One other thing is check that the battery terminals are actually tight, they can appear tight but sometimes they're not like -----> C but more like ------> O this happened to me and caused a lot of head scratching until I spread the terminal apart and filed the two inside surfaces down then they would tighten down all the way.
One other thing that can cause grief is that darn solinoid. If the internal brass bar becomes pitted it won't make good contact when it pulls in.
04-26-2008 12:05 AM
u2slow One trick I like is use a clamp-on ammeter on each battery ground while cranking. That tells you which battery (or its cabling) is not puling its weight.
04-25-2008 02:17 PM
galaxiedan When I first bought my truck they had just put new batts in it. It didn't seem like it cranked very fast though. I put a voltmeter directly on the battery post when the engine was running and sure enough one battery was reading 14+ volts and the other was reading 12.5. The problem was a dirty connection. Make sure the inside of the terminals are very clean (they sell a little wire brush tool that is made to clean both the cable and the post). Cleaned the terminals and cranks much nicer now.
04-25-2008 10:36 AM
TravisT Cable ends at the batteries are OK. Havent checked the other end of the cables.

When you say check the "condition" of the cables, how can I check more than the visible ends?
04-25-2008 03:02 AM
STurbo90 also check the condition of the ground cables to the block. High resistance will lower the current.
04-25-2008 02:11 AM
sloate have you cleaned both ends of all the batt cables, see what the volt drop is from the batts to the starter.
04-25-2008 01:09 AM
TravisT
Bad starter? Batt Cables??

This makes me feel dumb.

I had one bad battery - one good battery. I replaced the bad batt with a good one but it didn't make a difference in starting.

Has over 12V just sitting there, cranking it gets down to near 10V. Keep cranking a bit and it drops into the high 9s.

But it sounds like the batteries aren't keeping up. Seriously sounds like batteries that can't handle a load.

So I put in two new Motorcraft batts as a test. Same problem.

Could this be a bad starter? It's only 8 months old - from ebay.

Is it possible to have a problem with the cables?

This is getting ridiculous. Is it possible there was a problem with the install?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome