Search Results for ‘7.3’

Hey guys, I'm considering putting my 7.3 engine into a different truck because the body is rotted away. My engine just rolled over 200xxx and is really strong. What all would I need change if I put it on a 6.0 frame with the 6.0 body. There is a guy with truck for a decent price and is a super...

Good morning all, I am upgrading some components on my stock 02 7.3psd cc long bed auto trans w/ 250,000 miles in order to do some heavy bumper towing. I have already gotten a 4 gauge a pillar with trans temp, boost, fuel pressure, and egts. I am putting a class V draw tite 2.5” hitch receiver...

So I decided to change the glow plugs in my truck after finding that only 3 were working. I replaced the plugs with Motorcraft brand, I replaced the valve cover gaskets with Dorman gaskets. I replaced the two glow plug/injector male connectors on the passenger side due to some slight melting...

I have a 2002 f350 sometimes would take longer than usual to start but parked it the other day after using it for the day and would not start. I gave it 2 days and tried to start it and took around 20 seconds of cranking to start. But did start. I let it run for a little and then when I shut it...

For sale is a 2000 Ford E350 Power stroke van. Location Is In Kenai. I bought it May of 03 at about 24k miles. The engine is stock, has injectors replace at 195,000 and a new high pressure oil pump installed when injectors where done. Trans is still factory. Has the tow, needs new wire at the...

Hello everyone! I am looking at the possibility of buying my friends 1996 f350 because he is moving away. It is burgundy red and is a 4wd crew cab long bed. It has no rust and has just a little bit of paint fading on the doors. It has a 7.3 in it and it had the transmission rebuilt 3 years ago...

With no indication my water pump bearing failed, does anyone have any insight or experience with this. I have not been able to recover any bearings and only one roller, will the balls and rollers damage anything if they end up in the water jacket, and if I put a new pump on with a new pump suck...

Alright so basically like the title says. 1995 f350 7.3 won't move now but shifts into gear. This started after we just changed the transmission pan/filter and fluid. We went with a deeper pan that adds 7 quarts. The stock pan and gasket were leaking and we couldn't get it too stop. It ran...

i have a 2000 model 7.3 that goes into a rough idle when you brake hard, like its losing most of the cylinders. shut it off and re start its fine until the next time you brake. the only code i get is for idm. i have already swapped the idm with a different one, and replaced the cps. buzz test...

Hey all, I have a 7.3psd CC LB 4x4 with 253,000 miles, looking to install an ignition kill switch. Can I just cut the starter wire before or after the little snap connection under the hood and splice into it? I’m not sure if it’s a single wire or actually a bundle, or if it controls other...

I have a 96 F-250 with the 7.3L and when you put it into reverse the truck will sometimes stall unless you give it some throttle even then it still will stall sometimes it also dies in manual 1st gear. The truck shifts hard and downshifts very hard as well. Tried pulling the pan to check the...

Hey all, I’ve got an 03 7.3 automatic with 350k miles. Since I’ve owned it for the past 2 years I’ve always had to let off the gas a bit to shift smoothly in higher gears. Today I got up to high rpms on the highway and it waited way too long to shift. It did this in from 1st to 2nd gear as well...

Long story short we were fixing our engine oil cooler and had the front tank out and had to replace the tank selector valve, we got the oil cooler fixed and started the truck up on the rear tank to check for any leaks in the oil cooler. Started up no problem, could tell it was getting low on...

I have a 97 f350 7.3 that has 150k miles. The truck ran good when I first got it but started having a problem with it running rough and not having any power. The truck could not be driven without it shutting off on me. So I started replacing parts that include (IPR, ICP, CPS, MAP, MAP sensor...

Okay anybody know what my problem is when I crank the truck up it idles rough when it warms up always also Burns fuel up the exhaust does not burn it but you can smell unburnt fuel coming out the pipe it warms up it seems to purr really good run good and the fuel quiz burning or does very little...

I’m looking at this 7.3 and just wondering if y’all see anything that would be bad with it. If I do buy it it would have to be delivered so I can’t actually inspect it myself. This is my first time buying one of these so I’d just like some advice, thanks.

I need help with a wiring diagram ( color pin out) old owner cut the wires from the pig tail and replace it with aftermarket wire (all one color) thanks in advance

SOS I have a late model 99 with a 4r100, I was driving to work one day and after leaving a stop sign truck had no second gear. From that point on the truck would wind out first gear to 25mph and smash itself into 3rd gear. Brought it to a trans shop as a bench job who said that second gear was...

Hey all, I have a 7.3 CC coming up on its 250,000 mile oil change. I made the mistake of buying 12 quarts of conventional oil and 3 quarts of synthetic blend. I really was not paying attention on this one, I usually run a full synthetic. My normal change interval is 5,000 miles. Both oils are...

Recently I’ve been having transmission problems on my early 1999 f250 SD so I got a donor truck to put the running transmission into mine. Same year same engine, everything matched up. I made a torque converter mistake when mounting it onto the engine and only realized I made the mistake when i...