10.25 sterlig rear diff specs

1272 Views 1 Reply 2 Participants Last post by Robsr70, Jul 4, 2005

MichaelM

Discussion Starter · Jul 4, 2005

Hey guys,
My neighbor is bringing his 93 F350 4X4 single wheel over in a little while to replace the rear pinion yoke and seal. I *think* its a sterling by the paperwork he has for it. What is the torque spec on the yoke nut after we put it all back together? There surely is no crush sleeve in this rear end is there? Can you tell me the backlash spec on the ring and pinion too? I am going to pull the cover and check that too.

Thanks for the help guys.

Michael

Save

1 - 1 of 2 Posts

Robsr70

· #2 · Jul 4, 2005

Michael:

Go to www.ringpinion.com, click on technical help, installation instructions, yukon installation instructions.

Should be everything that you need. This is what I used when I changed my gears.

Bob (robsr70)

PS: Yes there is a crush sleave!!

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month