The Diesel Stop banner
Cancel

6.0 trans cooler in a 01 truck

960 Views 2 Replies 2 Participants Last post by  SUPER WONDER DAWG, 
S
I just purchased a new 6.0 cooler from Ford. I have removed the aftermarket cooler I installed a few years ago. Does any one have any secrets to the install of the new cooler. I know I need to remove the stock 7.3 cooler and the lines for the replacement. Anything else I need to be aware of?

Thanks

THE DAWG
Reply
Save
Like
1 - 2 of 3 Posts
S
FORD4ME thanks for the reply. I did already loosen the AC condenser and pulled it forward. I then started drinking and put the project on hold till the weekend. I was going to connect the hoses to the trans cooler before I installed it. I think that will make the hook up a little easier. I did not notice the 3/8 and the 1/2 difference betweeen the cooler and the lines form the trannie. I guess I will work on that tomorrow.

Thanks again

THE DAWG
Reply
Save
Like
1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top