The Diesel Stop banner
Cancel

6.0L MAP intake port part number?

2860 Views 7 Replies 3 Participants Last post by  MCB, 
M
Does anybody have a part number for the brass fitting on the intake side where the MAP sensor tube connects?

I have an 06 F350 that has an ambulance engine in it. I just bought it. Boost is low and giving me a code. Noticed that when the jokers put the thing in apparently they plugged the hole where the fitting goes and never installed the tube running between the MAP sensor and the intake.
Reply
Save
Like
1 - 2 of 8 Posts
ford_doctor
Is the fitting missing and the hole in the manifold plugged or is the fitting there and it's plugged?
Reply
Save
Like
ford_doctor
I was going to get you the part number but you got it covered. :thumbsup: I had to get one when an intake manifold was returned to me from being cleaned with it missing.
Reply
Save
Like
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top