6 gun + DP Tuner

1246 Views 9 Replies 7 Participants Last post by CSIPSD, May 30, 2007

amortens

Discussion Starter · May 30, 2007

I currently have the Banks 6 gun & Big Hoss Chip installed on my truck. After reading in a recent post I've found out that maybe Banks was not the most ideal setup for my truck and what I was wanting. Been looking at the F5 DP chip. I'm assuming this will just take the the place of my Big Hoss Chip and still stack fine with my 6 gun? Is this a correct assumption? Also, I previously was running a TS 6-position chip and still have the dial installed, anybody know if the knob from the TS chip will plug into the F5 DP chip or will I have to install a different dial. The stup I am looking at for my DP chip only has 6 settings so I as far as positions on the knob I should be fine.

Save

1 - 3 of 10 Posts

trick76cj5

· #2 · May 30, 2007

you can use the 6 gun for the pyro guage if you wish, but Jodi's chip will do everything that both the big hoss and the 6 gun combined will do. . .plus some. I'd just dump it on ebay and buy gauges since there is no need for it stacked (nor will it be advised by jodi).

Save

trick76cj5

· #4 · May 30, 2007

6 gun is a module that plugs into the wiring harness. . .basically an over glorified resistor mod. . .it's not a program loaded into the computer. /ubbthreads/images/graemlins/wink.gif

See less See more

Save

trick76cj5

· #8 · May 30, 2007

get a fuel pressure guage /ubbthreads/images/graemlins/wink.gif

You could leave the 6 gun, but it won't do you anything other than being an expensive cap. . .i'd sell it on ebay, Banks stuff pulls a mint on ebay, then fill it with a useable guage, engine temp, oil pressure, fuel pressure.

See less See more

Save

1 - 3 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month