The Diesel Stop banner

a/c system question

986 Views 7 Replies 5 Participants Last post by  jmann
My a/c id not working properly - hot air comes out at times. I looked under hood and see we take the new type of coolant that you can recharge yourself. As I happen to have some with the qage on it, I figured I would check/refill it. I looked under hood and there appears to be two valves: one on the left side (looking at enging from the front) near the firewall and one on right side near the radiator. Both valves seem to look the same and neither is labled. They both are part of cooling system. The one on left side into black box and the one on right goes to a line into compressor. which one to I hook the charging unit up to? Also any ideas what else besides coolant could be the problem? I see no leaks in system and it worked fine last summer. Thanks
1 - 1 of 8 Posts
To check your heater/cooling fins, simply remove the 4 screws holding your blower motor into its housing, then pop the fan out (remove electrical connector first) and you'll see the fins down inside the housing.

Flush out with some clean water and some have been using a coil cleaner made for AC coils to clean them..

Good luck,

TFB
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top