The Diesel Stop banner
Cancel

aeromotive regulator problems

3357 Views 4 Replies 4 Participants Last post by  Strictly Diesel, 
J
A couple of days ago I noticed that my truck was idling rougher than normal. I checked my aremotive fuel pressure regulator and the pressure was up around 100 psi! (Normally its 64 psi). Then I shut the truck down and the pressure stayed at about 40, and did not bleed down like it should. I then started it again and tried to adjust it back down from 100 and 70 psi was as low as it would go. Any ideas??
Reply
Save
Like
1 - 2 of 5 Posts
J
After making a couple of phone calls and a little more trial and error (removing fuel line from reg. after power is off and pressure stayed the same)I figured out that I just had a bad pressure guage. The reg. is just fine!!
Reply
Save
Like
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top