Am I right?

795 Views 2 Replies 2 Participants Last post by Roosterq, Mar 4, 2009

Roosterq

Discussion Starter · Mar 3, 2009

The "Check Gauges" indicator came on, in my dash (Not check engine) and all the gauges seem to be working except the Oil pressure gauge. The needle seems to be stuck in the middle of the gauge, even when it is off. I have a mech oil pressure gauge so I know I have good oil pressure. Could the "Check Gauges" indication be caused by a bad oil pressure switch?

Save

1 - 1 of 3 Posts

fordboyyfm

· #2 · Mar 4, 2009

the gauge should be down not in the middle if the switch was bad, sounds like you might have a problem in the cluster

Ford certified diesel tech
96 PSD reg cab 4x4 auto 4.10 LS rear xlt. 4" superlift 35" BGF Muds on 16.5 mickey thompsons, dual stabilizers, 3" glass cowl hood, custom american patriot headlinner, Beans stage I's, TS Performance 6 pos. chip, SD HPOP, BB in fuel regulator, custom intake, 3" downpipe, 4" straight pipe exhaust and 5" tip. All aluminum radiator, 6.0 trans cooler. Banks pyro, trans temp and boost gauges on the pillar. TransGo shift kit, billet converter. 10" rear drup bumper, custom droped hitch receiver billet grille, custom front bumper with fog lights and billet grille, diamond cut headlights, clear corners and markers. Viair compressor, one gal. tank and dual air horns.
90 mustang 347 race car.

05 f250 red supercab 6.0, suncoast auto trans, 4x4, long bed fx4, grey interior. atc 275cc injectors, turbonetics ceramic coated 70mm turbo, head studs, aeromotive fuel system, sct with innovative tunes, dual 5" stacks.

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month