The Diesel Stop banner

Bizarre no start on 2002 7.3L

1174 Views 8 Replies 4 Participants Last post by  bigb
Hi guys,

A friend of mine and I have been working on his 2002 7.3, and still cannot get it to start. We have been through the wiring harness, replaced most every sensor including ICP. Replaced the IDM module and checked power to it, and still no start. Connectors to the IDM are clean and seem ok.

It's acting like it's not getting any fuel, even though we've been through the feed side, lift pump etc, all are good and we are getting good flow into the engine compartment. It will puff a little smoke on cranking but not like normal, and no start.

After many hours we are at a loss. Any suggestions?
1 - 1 of 9 Posts
You can get Torque Pro for Android at Google Play for $7.50, then get a ELM 327 Bluetooth adapter for $12 to $15 on Ebay then you can monitor all your sensors while cranking. Very difficult and expensive to troubleshoot a Powerstroke without a capable scanner.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top