The Diesel Stop banner

Brake line attachment leak

12405 Views 8 Replies 5 Participants Last post by  FMTRVT
After installing a new rear brake caliper on my 2001 drw f350, there is a brake fluid leak where the brake line is attached to the caliper. Was I supposed to use some kind of sealant in there to seal it? Or is the surface of the new caliper defective where the brake line is attached? Or is there a piece of dirt or sand in there? Any ideas? I don't think that there is a little gasket or seal that goes in there.

1 - 1 of 9 Posts
Did you replace the crush washer on the bolt???
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.