Brake line attachment leak

12378 Views 8 Replies 5 Participants Last post by FMTRVT, Dec 31, 2008

DonWarkentin

Discussion Starter · Dec 23, 2008

After installing a new rear brake caliper on my 2001 drw f350, there is a brake fluid leak where the brake line is attached to the caliper. Was I supposed to use some kind of sealant in there to seal it? Or is the surface of the new caliper defective where the brake line is attached? Or is there a piece of dirt or sand in there? Any ideas? I don't think that there is a little gasket or seal that goes in there.

Thanks.

2001 F350 XLT 4X4 crew cab, dual rear wheels, long bed, black, 7.3l turbo diesel, automatic transmission, 4.10, shift on the fly, running boards, sliding rear window, 38 gal fuel tank, Odyssey extreme 65-PC1750T batteries, Michelin LTX-MS2 rear tires, Sumitomo Encounter front tires, Shell Rotella Ultra elc, 11,500 gvwr, 20,000 gcwr, 7500 gvw, completely stock, 114,000 miles when purchased, now has 250,000 miles, repairs so far: two starters, batteries, cps, brakes, tires, alternator, ball joints, locking hub, wheel hub, AC compressor, serpentine belt, power steering pump, driver's side window, ignition switch, o-ring, Spectra premium radiator, water pump, fan clutch, fan blades, thermostat, thermostat housing, tensioner. Stolen twice so far, but recovered both times with major damage.

2005 Nomad Rampage toyhauler made by Skyline. 11,500lb gvwr.

Save

1 - 1 of 9 Posts

agdodge4x4

· #7 · Dec 31, 2008

hmmm...ive reused those copper washers before with no problems.

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month