Brake question - quick answer appreciated

1406 Views 16 Replies 10 Participants Last post by swh22, May 20, 2006

swh22

Discussion Starter · May 14, 2006

I have my rear, driver's side wheel and drum pulled off to check my brakes (failed inspection, no braking from that wheel). The entire brake assembly is covered in grease, which certianly explains the braking problem. But what is causing this, a broken seal to the axle? Anything I can replace or just clean it all up and forget about it?

Thanks,
Steve

Save

1 - 1 of 17 Posts

BlueMule

· #8 · May 15, 2006

[ QUOTE ]
Make sure you replace the brakes also. They will never work right again after they have been contaminated with lube.

[/ QUOTE ]

Hhmmmm......I thought thats what BRAKE-KLEEN was for..... /ubbthreads/images/graemlins/shrug.gif

See less See more

Save

1 - 1 of 17 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.