The Diesel Stop banner

Cannot to save my life get the icp sensor out. help

989 Views 7 Replies 3 Participants Last post by  jetjockey99
i am about to kill the truck i am so frustrated. i went through the top of the engine to get to the icp.

the only way i can get the crow foot around the sensor is with a breaker bar (no extension) and then i can't get any leverage to break it loose.

from what i have seen says to use an extension and a ujoint but it's so clumsy i can't get the crow foot around the sensor. i've tried going up from the bottom but with my back the way it is and the lift on the truck my arms just aren't long enough.

what am i doing wrong here. how should the wrench be set up? there is just nothing on this topic that is clear and consise and it drives me crazy. all the write ups i have seen are worthless without demonstration of what to do.

i am tempted to pull out the turbo and then i would probably be done but i would rather not
1 - 3 of 8 Posts
I do them from the bottom, I just cut a deep socket down tell it fit.
Only ones I've done from the top I already had the turbo was out.
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.