Changing gauge cluster,

2032 Views 8 Replies 5 Participants Last post by '03 Tanker, 3 mo ago

RJC2

Discussion Starter · Jun 12, 2011

03 F250 XL 5.4 6 sp.
I recently had my fuel gauge stop working. (below E when full) Replaced the sending unit and found the old one to be good so it wasn't that. (replaced it anyway)
I have moved on to "guessing" the gauge cluster is bad. I have located one that will work, it is used but it is high mileage, my truck has 48K on it.
Question,
Is the odo changable? Can I use my old odometer (w/ 48K) in the used higher mileage cluster???
Also, the replacement is for an auto. trans.. I have a 6 sp.. Will that work out okay?

Thanks,,,

Save

1 - 1 of 9 Posts

bugman

· #8 · 3 mo ago

I think that you will be in for more work than you would even think of.

I'm not sure of when the went from the GEM module to the BCM but that could be one of the problems.

The days of swapping out a old cluster for a newer one are long gone.

Save

1 - 1 of 9 Posts