The Diesel Stop banner
Cancel

E4OD wiring diagram

36831 Views 10 Replies 6 Participants Last post by  danjreed, 
Deib
How do I trouble shoot the TC circuit without a scan tool?

I know there is the purple wire with yellow stripe, it should lock up if I ground that.

So where does it get it's power? Is there more than one wire that controls or supplies power to the TC convertor.

I am looking for ways to test the TC circuit inside the tranny so I can figure out if my problem is internal or external.
Reply
Save
Like
1 - 1 of 11 Posts
Mark Kovalsky
If you have the right wire and everything in the torque converter lockup system works, grounding the wire in park will lock the torque converter.

Locking the torque converter in park causes absolutely nothing to happen!

If you were to ground the wire with the trans in drive AND YOUR FOOT HARD ON THE BRAKE it will stall the engine if everything is working.
Reply
Save
Like
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top