[klhansen]

Here's some part # info from This website

Fuel Filter Housing Reseal Kit
(International) 1823645C91 (94-95) (Part # inside Ford packaging, bad per IH)
(Ford) F6TZ-9157-BA (96-97)
(Ford) F5TZ-9157-A (94-95)
Includes:
(Ford) F4TZ-9C064-A O-Ring Water in Fuel Probe
(Ford) F4TZ-9C065-A O-Ring Heater Connector
Not Available (International) 1823565-C1 O-Ring Water Drain Valve
Not Available (International) 1823635-C1 O-Ring Orifice Vent
Not Available (International) 1823644-C1 O-Ring Pressure Regulator Filter
Not Available (International) 1823655-C1 Ball, FPR Check Valve
Not Available (International) 1823662-C1 Gasket, Element
Not Available (International) 1824476-C1 O-Ring, Prescreen Bowl

 

[1064RG]

I found this http://cgi.ebay.com/ebaymotors/Ford-Powe...1QQcmdZViewItem on ebay. Seller says that they fit 99+. Will they fit OBS?

 

[1064RG]

I answered my own ? w/ a little more research. And found a kit that had the little oring in it. The obs needs the little one, and the sd's don't.

 

[jtownes14]

Hey. I have a 1996 Ford F350 7.3 Power-Stroke. I have diesel puddled on top of my engine and disel dripping down on the trans and starter. Is this what you are referring to? HELP...

jtownes14

 

[fsj cowboy]

I just talked with the parts dept with my local Ford dealer. Said they sell a seal kit for the valve for ONLY $36!!! I ordered the o-rings from McMaster-Carr....1 package of 25 lists for under $6....a real no-brainer.

 

[rollernose]

I have a 95 f350 leaking from the water in fuel probe, or the heater connector. What ever the one with the single red wire going in is. Does anyone know what the O-ring size is for that fitting? Ford wants $46.00 for a reseal kit for the fuel bowl. I bought 20 ea. viton #202 and #013 at a local seal wearhouse for $5.00, & would like to purchase the rest of the seals from the same place. I just need sizes.

Thanks

 

[NWsurfer]

Hey Rollernose, I'm having the same problem. Mine is coming from the same spot (red wire going in at the top of the fuel bowl) and when I looked up replacement o-rings the website said that the O-ring will not stop the leak and the whole sensor had to be replaced...
http://www.dieselorings.com/index.php?page=details&prod=14&cat=3&group=2

Anybody else have any other suggestions or similar experience?

thanks

 

[NWsurfer]

Ok, I stopped by the local diesel mechanic and bought a Water In Fuel sensor. The problem with it has nothing to do with orings... it is the sensor itself. 60 bucks and a crescent wrench and it is fixed.

 

[SuperDutyFiver]

A quarter inch thumb wheel rathcet works really well with a torks bit...thin k it s a#10 but not positive. The seals can be done without removing the bowl-even with descent sizt hands!

 

[jdmorris76]

there is someone selling these on Ebay and it includes the small oring for our year model for $3.00 not shipping.

 

[mk3drift]

could this cause the truck not to start when its warm. i noticed i have fuel in the valley i cant figure out where its coming from and i dont know if it was doing before

 

[Sabir]

sabir

Hi, This post is very informative, however I would like some specific information. If someone can help me then please send me a private message. Best Regards,

 

[trukpro]

i recently replaced the o-rings on the drain valve....picked up the three o-rings off ebay with not so accurate instructions. i had to pull the whole filter assembly from the engine to gain access to the #20 torx screws to remove the valve....after that it was easy. unfortunately it didn't fix what ever is leaking.

justin
'97 f250 ex. cab

 

[presvt]

I am experiencing a fuel leak and doing searching here to be prepared on what to look for before I tear into it....when I click on the link in the first post I get a message saying I am denied access to that thread and don't have permission to view it.......any real reason for that? is this privledged information? if so, why? I have always found this forum to be a help and this seems a bit counterproductive.

 

[JamesFelix]

Jim Felix

I am experiencing a fuel leak and doing searching here to be prepared on what to look for before I tear into it....when I click on the link in the first post I get a message saying I am denied access to that thread and don't have permission to view it.......any real reason for that? is this privledged information? if so, why? I have always found this forum to be a help and this seems a bit counterproductive.

I'm having the same problem with my '97 SDPS and with the website. Hope we get both answers.

 

[JamesFelix]

Is there a site that has a diagram of the fuel system to help me better understand just where this filter drain valve is located and what I'm getting into?

Great site. Helpful reading.

 

[klhansen]

I am experiencing a fuel leak and doing searching here to be prepared on what to look for before I tear into it....when I click on the link in the first post I get a message saying I am denied access to that thread and don't have permission to view it.......any real reason for that? is this privledged information? if so, why? I have always found this forum to be a help and this seems a bit counterproductive.

Sorry guys, the software conversion of the website messed up the original link (and lost the photos). :icon_rolleyes:

I just reposted the photos and linked directly to them. :thumbsup:

Kevin

 

[Scott D]

Great info in this thread. I have a fuel leak I need to fix.

 

[LunaTech]

Looks like the little green bands we use when banding calves :laugh::stickpoke:

 

[Drock96]

i have a fuel leak, it is coming out of the bottom of the fuel filter i believe... or it looks like it is at least... Could this be the same thing as what your referring to?