You would be losing a lot of cooling capacity. Hard blok is good for short runs, i.e. pulling or drag racing, but for going down the road, I think it would just lead to problems.
Hard Blok water jacket filler
I am slowly piecing my 7.3 back together from a scored rear cylinder, that dumped diesel into my oil, so far I have a fresh .020 block and a turbo reciprocating assembly, that I still have to massage and assemble, I wonder if I fill the coolant passages half way with Hard Blok filler after I done the boring and honing, will it be an issue? Why did I wait till now to think of this???:icon_rolleyes:
always happens this way. since these engines are a little thin I don't see any problems doing this. anyone else thought of this? also anyone have a good set of bare casting heads?
always happens this way. since these engines are a little thin I don't see any problems doing this. anyone else thought of this? also anyone have a good set of bare casting heads?
1 - 1 of 11 Posts
1 - 1 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
