Hole in the IPR screen

3799 Views 7 Replies 5 Participants Last post by dillon134, Oct 11, 2015

bigrick56

Discussion Starter · Oct 9, 2015

What does this usually mean thanks in advance

1 - 1 of 8 Posts

It means a piece of trash went through the high pressure pump and through the IPR screen. It may be lodged inside and is a good reason to change the IPR. There are some videos on Youtube about taking the IPR apart and cleaning it, but I don't know what degree of success there is with that.

2006 F250 Lariat Supercrew, ESOF 4x4, 18" tires, FX 4, HD Alt., block heater, Integrated Trailer Brake Controller, Upfitters, power rear window, cab lights - delivered 10/25/05

Ford Remote Start; High idle mod; Timbren load levelers, Scangauge II, Blue Spring upgrade, Quick Start 200 amp large frame alternator, 2 batteries January 2010; GPCM replace October 2011; 2 EGR valves; EGR Cooler replaced 12/30/11; Performance Machine & Mfg. coolant filter added 1/2/12; Rotella T6 5W40 oil; turned rotors, replaced brake pads for 1st time 1/7/12 101K miles; GPCM, both subharnesses and all 8 glowplugs replaced 1/5/13 at 118,000 miles; 2 Ford batteries replaced under battery warranty twice, the latest 9/18/2015; FICM power supply board replaced with Dorman board 11/20/13. Coolant flushed and replaced with Prestone ELC 9/27/14. STC fitting 10/19/14; Dummy Plugs 11/8/14; Turbo rebuilt 11/29/14; cold side CAC tube and boots replaced with metal tube 1/24/15; replaced hot side boots 1/30/16.

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Hole in the IPR screen

bigrick56

Ford06

Top Contributors this Month