The Diesel Stop banner
Cancel

How much ATF in the transfer case?!?

1015 Views 12 Replies 5 Participants Last post by  ryanPSD, 
R
The manual, if I read it right, says 2.0 quarts. I remember reading several times online 2.1 quarts is when it should start coming out the fill hole, so I only bought three... I just put in 3 quarts and it was all still going in when I finished.

Do I need more, to reach the fill hole? Am I fine? Too much?!
Reply
Save
Like
1 - 1 of 13 Posts
A
So just to be sure cause I think there are 2 things going on here...the tranny takes MTL which is a popular change, but the transfer case takes automatic tranny fluid, at least that is my understanding. I don't remember reading about anyone putting MTL in the transfer case. Could be wrong though /ubbthreads/images/graemlins/shrug.gif.
...on research Redline recommends D4-ATF for replacement in units that require Dexron auto-tranny fluid..


Art
See less See more
Reply
Save
Like
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top