The Diesel Stop banner
1 - 1 of 1 Posts

·
Registered
Joined
·
93 Posts
Hope you dont mind a contribution with a partial alternative method..

I am not shy about modifying tools so they work..

In my case I was able to remove the old ICP with a deep 1-1/16" socket

However to thread the new sensor into place, I decided to not sacrifice yet another tool to the person who shall be forever vilified for placing important sensors in impossible (almost) to service locations...

May the person who approved mounting the fuel filter horizontally, be showered in diesel in perpetuity...

I digress....

To thread the new sensor in,, I simply used some electrical tape and taped together a universal joint,and extension...

Got the sensor threaded in... unwound the electrical tape, pulled the uni and extension... used the deep 1-1/16 to tighten.... job done..
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top