The Diesel Stop banner

Hypermax wire ring head gasket assembly for 600 bucks, no machining required!

2992 Views 9 Replies 6 Participants Last post by  BIGBEAN
Hypermax Engineering


Ah, so much less of a pain in the toot than the down time and cost of machining.

Heck, that's only double what a factory gasket costs. /ubbthreads/images/graemlins/grin.gif


[ QUOTE ]
Eliminate blown head gaskets with this assembly, and no machining of the head of block needed. Works well with programmers and in-line modules. Keeps you truck from whistling like a tea kettle. If you run over 30 Psi of boost then this is what you need!
Applications: 2003-2006 Ford F-Series pickup and Excursion with 6.0L Power Stroke diesel.
Do-it-yourself installation instructions included.


[/ QUOTE ]
See less See more
1 - 2 of 10 Posts
I like the idea of no machining, but will they hold up as well as ringed heads? If so, then its a no brainer, if not then receivers should be machined as long as heads are off. What am I missing?
Then it seems that machining is a thing of the past and these new gaskets should be the default for any head gasket replacement. Has anyone tried them yet and if so what mods do you have?
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top