The Diesel Stop banner

Hypermax wire ring head gasket assembly for 600 bucks, no machining required!

2991 Views 9 Replies 6 Participants Last post by  BIGBEAN
Hypermax Engineering

Ah, so much less of a pain in the toot than the down time and cost of machining.

Heck, that's only double what a factory gasket costs. /ubbthreads/images/graemlins/grin.gif

Eliminate blown head gaskets with this assembly, and no machining of the head of block needed. Works well with programmers and in-line modules. Keeps you truck from whistling like a tea kettle. If you run over 30 Psi of boost then this is what you need!
Applications: 2003-2006 Ford F-Series pickup and Excursion with 6.0L Power Stroke diesel.
Do-it-yourself installation instructions included.

[/ QUOTE ]
See less See more
1 - 3 of 10 Posts
I had their 420 box on my 04 and it was flawless. /ubbthreads/images/graemlins/cool.gif
See less See more
IMO, they are a strong upgrade that you can install in a day.

Machining for o-ringing is in the 1200.00 range and the o-ring gaskets cost 500.00$ more than these, so your saving 1700.00 bucks and quite a bit of downtime.

They are strong enough to take any fuel upgrade that does not require the bottom end to me modified. /ubbthreads/images/graemlins/biggrin.gif
See less See more
1 - 3 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.