I have never service my brake slide pins - what parts will I need? will be getting new rotors

1173 Views 5 Replies 5 Participants Last post by NCHornet, Apr 20, 2006

clydesdale

Discussion Starter · Apr 20, 2006

Well i have warped rotors and I have never serviced the slide pins. I have 65k and want to replace my rotors and service the slide pins. I have an 02 and hear that the pins have been upgrade and some sort of bracket. Anybody know what I need and what the part numbers are? Thanks

2002 F-250, PSD 6-speed, CC, short bed, 4X4, Toreador Red w/ Silver accent, A.R.E mx cap, Weld Super Single II and 33s in the summer, x-springs, F-350 blocks and badges, AIC, proflaps, ITP intank mod, AirDog with 3 micron filter, isspro guages and TTM, scangauge, husky liners, alarm, xm stereo,stull 5399-p grille, centramatics, ccv mod, AIS Air Filter, Southbend CON O, Detroit Truetrac LSD, coolant filter, 203 stat with billet housing, blackcloud intake heater plug/boost fitting, reese titan hitch, fabcraft PTO cover/temp sender port, prodigy brake controller, ITP Boost Annihalator, oilguard bypass filter, Mag-Hytec rear dif, bilsteins, hellwig rear stabilizer bar, ATS housing, non-ebpv pedistal and exhaust flange, magnaflow 3.5dp exhaust, ITP reg return, turbomaster wastegate controller, and ceramic coated bellowed up pipes, PHP 50t and 80p, currently 127,000 miles.

Save

1 - 1 of 6 Posts

NCHornet

· #6 · Apr 20, 2006

I just went and bought some of the Ford XG3 Lube today. Ten bucks and you know it is the right stuff. I am doing the same job if you have any ?? just PM me. I am also going to flush all my fluid and replace with a good quality brake fluid. I bought the Valvoline that meets DOT 3 & 4 requirements.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month