The Diesel Stop banner

IDM mod again

829 Views 3 Replies 2 Participants Last post by  Ford_Forgotton
Will the IDM mod work well with the mods listed in my sig., or will I be pushing it a little too hard with the powder metal rods in my 01. I have to keep this truck reliable.
1 - 2 of 4 Posts
Have you ever DYNO'd it?

If your under 400HP (which you are based on your listed mods) then it wont hurt to try. However, without a baseline DYNO run, your not going to know what, if any, change the IDM mod made.
No I have not had it on adyno yet, and I usualy run my 2K-18K mod in the 10K setting so I am sure that I am well under 500HP. Probably around 325 most of the time just going from what others post on here. I was just worried about other problems that could creep up.

[/ QUOTE ]

Unless you have a tuner or chip in addition to your 10k (2-18) mod, your not anywhere near 325. More likely 250 and thats on the HIGH end. Intake and exhaust help with EGT's which allow you to run a hotter programmer to make more power.

Am I missing something in your signature that would warrant 325?
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.