in need of help

2690 Views 21 Replies 5 Participants Last post by bberry09, Oct 26, 2011

bberry09

Discussion Starter · Sep 12, 2011

Well i changed my valve cover gasket on the passenger side, put a new vaccum pump on, and replaced my fuel filter. I took my batteries out and had them charged. I found that i have red wire and black wire still unhooked and dont know where they go. I have a wire running to the alternator. Does one go to the vaccum pump? And i have a wire unplugged coming from the fuel filter. I know one goes under the fuel water seperator but idk where the other goes. I looked on ebay for a shop manual and found a 1993 but idk if it be the same on my 90. Can anyone help

Save

1 - 3 of 22 Posts

drinkypoo

· #3 · Sep 12, 2011

one wire to the bottom of the fuel filter for water (bullet connector) and one on top for fuel heater (armored spade connector)

there is a low vac sensor on the fender apron (the plastic part) that takes some wires.

Save

drinkypoo

· #19 · Oct 14, 2011

the new exhaust will probably only come up to the Y-pipe, so no, you can't cut anything there.

Due to the oil leak I would also look at all the stuff underneath the truck in that area and behind it like transmission linkage etc.

Save

drinkypoo

· #21 · Oct 25, 2011

for gaskets in the exhaust system you want the metal-faced ones. then to make nice circles there is an expensive tool

Save

1 - 3 of 22 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month