[mykldn]

My first time doing so. Any info/instructions/pics/"atta boys" are greatly appreciated.

/ubbthreads/images/graemlins/biggrin.gif

Thanks, all.

-Mike

 

[1997PSD4ME]

did you see the pics i made you from my manual in your other post? do you want the instructions now for this? /ubbthreads/images/graemlins/shrug.gif /ubbthreads/images/graemlins/smokin.gif
click the beast in my sig to get to the 2 pics for you. let me know what else. is this pump seal like tha same thing in the pic? i'm not an auto guy? if you click make pic big you should be able to see ok.

 

[Richter69]

another tip for seal install, pack some "transgel" or thick petroleum jelly in the groove on the backside of the seal, this will retain the spring as it can pop out during install and leak. also use an aftermarket blue or black seal, the ford one is very soft and will relax and leak when the fluid gets very hot.

 

[mykldn]

[ QUOTE ]
did you see the pics i made you from my manual in your other post? do you want the instructions now for this? /ubbthreads/images/graemlins/shrug.gif /ubbthreads/images/graemlins/smokin.gif
click the beast in my sig to get to the 2 pics for you. let me know what else. is this pump seal like tha same thing in the pic? i'm not an auto guy? if you click make pic big you should be able to see ok.

[/ QUOTE ]

I did get the pics from the other post....thanks so much for them. However, they're a bit hard to read.

/ubbthreads/images/graemlins/frown.gif

I think I can make-out the torque spec sheet. But, the pump sheet is a bit too small.

The job sounds pretty straight-forward. I have a buddy helping me, as well.

Thanks for the information, all!

Regards,

-Mike