The Diesel Stop banner

JL CleanSweep

3273 Views 5 Replies 3 Participants Last post by  GrmReaper
So folks I am at a loss as to where to mount this massive thing.

Picked up a HD900/5 and a 13tw5 Sub and a Cleansweep, think I have it figured for the amp, but where to put this cleansweep that it wont be in the way yet close enough that i can have access to the volume control knob would be great.
Suggestions would be awesome. And under the drivers seat isnt an option because that is where i have my cell booster installed, Worse comes to worse I can move it but would prefer not to.

And where did you tie in to? I have the stock HU w/o NAV , but i have the sub. So I am pretty sure i dont have a speaker amp, just a sub right behind the Headunit seems most logical to me.
1 - 1 of 6 Posts
I don't have the Cleansweep (didn't want the associated volume control issues) but do have your other components: JL HD900/5, JL 13tw5 and Spl2k box. I purchased an Audio Control LC6i, mounted the converter and the amp in the storage compartment under the rear passenger seat. Both fit snugly and I can access them pretty easily (not while driving of course) for adjustments. Can you not get a detachable volume control knob on the CleanSweep? I thought you could get something that plugs into the unit where you can mount the dial anywhere, I could be mistaken though. Anyways, there's a couple of pics of my setup here:
What new thing did you learn about your 2011 SuperDuty? - Page 12 - Ford Truck Enthusiasts Forums

As far as tapping into the wires, mine was done behind the head unit. I tapped into the sub wires from the factory speaker wire in the back.
Any issues with overheating on the JL being mounted in the storage bin? I am going to put mine behind the seat so it gets some air flow. I am also going with the Audio Control LC6i, I think it is a better unit than the CleanSweep and doesn't have the volume knob issue. Also, it is all that Audio Contol makes so I am confident in their ability to put out a good product.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.