The Diesel Stop banner

1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I knew from glancing at it that the MLPS wiring harness would be a pain to fix up, but it's worse then I ever imagined. I've got at least 14 splice connectors and over 10 spots where bare wiring can be seen.

So.. I'd like to verify that the current setup is correct. Can someone post a wiring diagram for a 1997 F250 MLPS? I've seen a couple of pictures of various years, but I don't know if they apply to me or not due to the difference in years.

I should note - the new sensor came with the new plug and a diagram showing the old pin layout to the new one. The truck has the new connector, but I don't trust whoever worked on it last to have read the directions and correctly assemble the new plug.

As usual, any help is greatly appreciated.
 
1 - 1 of 1 Posts
Top