My 97 PSD wont start cause the Edge Evolution programmer screwed it up. PLEASE Help

1019 Views 5 Replies 3 Participants Last post by James_ole_red, Jul 1, 2005

James_ole_red

Discussion Starter · Jun 29, 2005

I need some advice. I was downloading the edge evolution on my 97 F-350. It was being a real pain trying to load. I had to start over like ten times. Then it loaded and was setting the truck for the towing setting and it quit. Now it wont start and the darn programmer wont set my truck back to stock or complete the set up. I am lost PLEASE HELP

Save

1 - 2 of 6 Posts

BEECHBM69

· #2 · Jun 29, 2005

I would say call Edge and see what they have to say. I think worse case you'll have to have the PCM reflashed to stock. Just my thoughts, hopefully somebody with an Edge will chime in.
Hope you get it worked out..

Dan

Save

BEECHBM69

· #5 · Jun 30, 2005

I'm off of Indian River Rd. If you need any help, let me know.

Dan

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month