[lengleng]

I posted on this a little while back and some of the suggestions were PML and ORU. I looked into both and like them. I like the PML but only the polished ones and they are pretty pricy. I would like a good set for the front and rear in polished aluminum. I did see that Summit has ProComps, Summit brand, and Transdapt anybody use one of these? Any other suggestions or should I try to find a good deal on ORU's? Any sponsers sell them? Thanks for any advice or suggestions.

 

[freddyfast9]

I got my mag-hytec front, rear, and trans pan from www.dieselsite.com and they are as site sponsor and look good as well as functional.

 

[Mark Craig]

lengleng,

If you want polished the'll be pricey as they fins make polishing a real bear to do. Remember too the PML's add capacity the other brands you mentioned don't they are for looks only which is fine if that's what you're after anyway. The PML's extra capacity helps keep the fluid at a lower average temperature.

mark @ DPPI

 

[genesiscom]

I got PML's because of the higher fluid capacity and they look great.
(price was right,also)