Your factory coolant/water gauge is nearly useless. It would make much more sense if you have a SGII to enter the codes for your water temp and then monitor EOT/ECT together on the monitor. Those two gauges never leave my monitor, and then i rotate the other two slots to batt volts,ficm v,vgt etc.
need help with setting up scanguage2 and boost
I was wondering if someone could help me dial in my codes for my scanguageII to show the boost. I have a stock f350 psd 6.0 I live in detroit michigan. I tried putting the boost code in. I am sure i have the altatuide formulla wrong or something. It shows betwenn 2-12 psi I also have the ect and trans programmed into it. them seem to be working good. Also is the factory coolant temp good or do i need a new code for that? and is their anything else i chould progam into it to keep an eye out for? Thanks for any help anyone can provide.
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
