need help with setting up scanguage2 and boost

1961 Views 7 Replies 4 Participants Last post by deliberate, Jun 22, 2011

whaley01

Discussion Starter · Jun 21, 2011

I was wondering if someone could help me dial in my codes for my scanguageII to show the boost. I have a stock f350 psd 6.0 I live in detroit michigan. I tried putting the boost code in. I am sure i have the altatuide formulla wrong or something. It shows betwenn 2-12 psi I also have the ect and trans programmed into it. them seem to be working good. Also is the factory coolant temp good or do i need a new code for that? and is their anything else i chould progam into it to keep an eye out for? Thanks for any help anyone can provide.

Save

1 - 3 of 8 Posts

ex mounty

· #2 · Jun 21, 2011

I found a thread on the powerstroke nation forum that may answer some of the questions you might have. I do not have the scangauge2 but I found the thread interesting. <CLICK ME>

Save

ex mounty

· #4 · Jun 21, 2011

I knew it would do that if I posted it in the fashion that you did, but was unaware that it would change a hidden link.
How dumb is that that they will not allow the cross referencing of forums that have better info?
Should I just copy the entire thread here with all 180 pages filled with codes to program the scangauge2?
dumb....
well here it is, remove the spaces....

www. powerstroke nation . com/forums/showthread.php?t=93317&highlight=scangauge2

Save

ex mounty

· #6 · Jun 21, 2011

I think he meant the factory "scangauge2" setting for the coolant temp....
or at least that is what I assumed he meant......

Save

1 - 3 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month