The Diesel Stop banner
Cancel

New Heater Cores Won't Fit

1074 Views 3 Replies 4 Participants Last post by  Fordiesel69, 
B
Between the time of my old heater core and now, they have redesigned the cores. It is now an aluminum core with different design on the tanks on either end. The new design will not fit in the box. The old core was a copper/brass unit. I have tried all the parts stores and I can not find my old design. Does anyone know where I can find one other than the stealership?
Reply
Save
Like
1 - 1 of 4 Posts
I
The aftermarket cores wont last. I have used 2 differant aftermarket cores and they both lasted about a year. I maintain my coolant at the top of the condition with distilled water so its not the water here. I finally bought the Ford core and now 5 years later no problems. I usually don't buy from Ford but this time it worked out for the best...
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top