The Diesel Stop banner

Oil Cooler O-rings?

3424 Views 4 Replies 4 Participants Last post by  cdnsarguy
I have finally gotten around to removing the oil cooler. The heat exchange element is good, but the 2 larger o-rings came out in pieces. My questions is where can you get the o-rings without going to the dealer? Everybody has the gaskets, but nobody can locate the o-rings.

The cooler came out with no problem. I just disconnected the steering arm. My mechanic buddy said to remove the motor mount and at first I tried that. After looking at the floor jack next to my face and realizing this could become a long visit to the emergency room. I went with disconnecting the steering shaft. These trucks do not have airbags so no problem with that issue.
1 - 1 of 5 Posts

Front seal/gasket number E3TZ-6A636-G $3.58
Rear seal/gasket number E3TZ-6A636-H $4.04
innner O rings 1C3Z-6C610-BA $3.58 each
Outer O rings 1C3Z-6K649-BA $9.19 each


DRAWER GASKET 1804378C2 $4.31 US
DRAWER GASKET 1804377C4 $4.31 US
1217175 RING 1807563C1 $10.07 US
1217175 RING 1804414C1 $6.62 US

International (much cheaper). International parts #s are (each is a bag of 2 rings);

-thicker ring 1804414C1
-thinner ring 1807563C1
I just had some of these rings let go. Can you tell me where you got them for these prices?

Thanks in advance.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.