The Diesel Stop banner
1 - 5 of 5 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
i have a 02 F250 4wd and want to put a chip or module in. anyone have any expiercnce with the edge/attidude combo. what other companies make a good chip for a ford? lastly what is best air intake for the money. thanks so much for the info ahead of time.
 

· Premium Member
Joined
·
1,079 Posts
I think the Edge/Attitude setup is a bit overpriced for what you get in a 7.3L Powerstroke application..
It does nothing to help with shifting and you only end up with about a 75HP gain..

I would consider a TS Performance 6 Position Chip or if you want a programmer, the Edge Evolution along with a set of 3 gauges, Boost, Pyromter, and Trans temp.

As far as intakes I'd reccomend the AFE Stage 2 or the AIS Severe Duty Intake

Let me know if there is anything I can do to help.
 

· Registered
Joined
·
285 Posts
well i have the edge j/attitude monitor i like it. it is a bet pricey though but you get gauges no trans but o well the power is not to bad but if you all ready have gauges i would say talk to dp-tuner jodie can set you up with a nice chip or a reflash there are a lot more out there though good luck
 

· Registered
Joined
·
908 Posts
Banks Six-Gun gives you a Pyrometer and boost gauge with the added power and the Ford AIS is one of the best air intakes for our trucks. If you want even more power for towing a Banks Big Hoss chip is a good choice as well, but if you step up in power you will also need parts such as compressor wheel, exhaust and Big Head actuator as well.
 

· Registered
Joined
·
1,407 Posts
J/A will give you protection from exhaust over temp. It automatically cuts back on fuel when it hits a temp you program in. It does not change the shift pattern but will do a defuel as it is doing a full power shift. I think the 2 defueling things it does makes it a good value. I like the J/A and it will produce a goody increase in power along with the gauges.
Jim
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top