The Diesel Stop banner

P1211,P0470,P1670,P1000,P0683 Help!

3399 Views 5 Replies 3 Participants Last post by  Kanman
Ok so truck runs fine but im getting these codes and it doesnt seem to have that much power. Im not sure where to start? do you think a bad PCM? I am unable to do datalogging with the cortex or my computer and Palmer engineering software. Where should I start? thanks guys its a 2000 excursion 7.3 with straight through exhaust and K&N filter.
1 - 3 of 6 Posts
thanks also I cant connect to do any datalogging its says com port error make sure ignition is on.
the fuse is fine as it will connect but then loses its connection. and the cig lighter works.

today it took six tries to get the truck to start....seems like a glow plug related issue ... I did get a code for glow plug control module not communicating properly to the pcm
1 - 3 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.